DDX™ V3 Adapter Set for CR-10v2 & CR-10v3
- Compatible with DDX v3, now even easier to install
- Fit a Direct Drive eXtruder on the CR-10 v2 and CR-10 v3
- Plastic Parts made of PA12 (Nylon) with the SLS 3D printing process
- Better surface finishing and higher working temperature resistance
- Improved bowden and Z-axis end switch support
CR-10 v2 and CR-10 v3 Compatibility
To use this Adapter Set on the printer models mentioned above, you just need the default DDX V3 configuration : Bondtech DDX V3 For Creality.
All DDX hotend and bed levelling sensor adaptors are compatible with this setup. Keep in mind, when it comes to the bed levelling sensor, using one of our adapters will change the position of the probe. A change in the firmware may be required.
Notice: To use the DDX V3 on your CR-10 v2 or v3 a hotend upgrade is required.
Available options are:
- Bondtech DDX PH3 Copperhead Hotend Upgrade
- Bondtech DDX PH3 Mosquito® Hotend Upgrade
- Bondtech DDX PH3 Mosquito® Magnum Hotend Upgrade
- Micro Swiss All Metal Hotend Kit For Creality Printers
Install the hotend and hotend adapter inside the DDX V3 before applying the DDX Mount Plate.
What’s Included
- 1x DDX 5015 Fan Shroud
- 1x DDX Mount Plate for CR-10 v2/v3
- 1x DDX Bowden Mount
- 1x DDX Z-Sensor Plate for CR-10 v2/v3
- 7x M3 Square Nuts
- 2x M3x25 Screws
- 2x M3x20 Screws
- 1x M3x10 Screw
- 1x M3x8 Screw
Manufacturer’s Part Number: EXT-KIT-77-C-V3